Burgess Model 982, Electric Hot Thermal Professional Fogger, 115 volts AS42, FT982, 1614-1677, GTIN 841688003859 [AS42]

Click to enlarge

Your Price: $187.87
Part Number: AS42
Quantity:
Estimated shipping cost: $ 9.00

Thermal FOGGER ELECTRIC HOT Commercial Grade

Burgess 982 Electric Professional Thermal Fogger for Outdoor Mosquito Control or Commercial Odor Control

SteamBrite Item No. AS42 (960 watts / 8amps @ 120v)

USES: Electric Hot Fogger

FEATURES/BENEFITS:
This versatile fogger creates a dry fog, similar in nature to the smoke created by fire.
This dry fog follows the path of smoke & neutralizes the odor.
Can be used as a solvent sprayer by simply removing the heating barrel.
Comes with a durable aluminum solution tank.
You can't afford to compromise on equipment.
Designed for both residential and commercial applications, the Electric Thermal Mosquito Fogger has the professional performance you require.
Multi-jet nozzles ensure you reach the tightest cracks and crevices without leaks or dripping.
Stainless steel tank, brass wand and Viton seals provide maximum durability and will hold up to the harshest working conditions.
The same effective system used by professionals to kill mosquitoes that may carry the Zika virus or West Nile virus.

Commercial-grade fogger ideal for flood and fire recovery and eliminating pet or mildew odor
Can also be used as a highly-effective insect fogger - killing and repelling mosquitoes, biting files, and flying insects for up to 6 hours
The same effective system used by professionals to kill mosquitoes.
Removable heating element for electric spraying capability. Utilizes a 110V power supply.
For thermal fogging only use products formulated specifically for thermal fogging: oil or water-based solutions containing propylene glycol oils

110v Burgess Professional Fogger Model 982

Compare to Current or past OEM Associations:
16982150
UPC 0 34457 98200 8

Model F982

Model 190443
205713946
ASIN B006WVFIZS
FG-EGF-EA
F-982
0034457982008
FT982
190443
8 41688 00385 9
841688003859
B01DYI73XQ
G6289696
117164
1614-1677

Thermal fogger hot

The original fogger was manufactured for use with insecticides outdoors only, so the operator's manual provided by the vendor stated in the Safety

Note new Precautions & Operating Instructions:

SAFETY PRECAUTIONS

• Use outdoors only. Fire or explosion may occur if used in confined area.

Fogging - For Use Outdoors Only

However our application requires use of the fogger indoors for odor control.

To allow for indoor use the Safety Precautions & Operating Instructions were changed as follows:

SAFETY PRECAUTIONS

• Except as provided below, use outdoors only. Fire or explosion may occur if used in confined area.

Fogging - For Use Outdoors Only “except as provided in #6 below”

(Step #1 - # 5 remain the same as the original manual – Step #6 added as follows)

6. The fogger should only be operated indoors by certified, trained Fire and Smoke Restoration Technicians and certified, trained Odor Control Technicians and only in accordance with the IICRC (FSRT) Fire & Smoke Restoration Technicians and Odor Control Technicians (OCT) guidelines and standards.
Electric Hot Thermal Professional Fogger 115 volts Model 982

California residents: see Proposition 65 information
Eliminates mosquitoes, biting flies, and other pests for up to 6 hours
Treats an average 5,000 square foot yard in less than 10 minutes
Heats in minutes for hours of use with no offensive odor
110-Volt power supply version
Removable heating coil for electric spraying capabilities

Barrel assembly can have dents on side of them due to when the manufacture crimps them.
All units are brand new is factory sealed boxes.
In the past we have opened every single box, and every single fogger has a dent in the barrel and this is how they make them! All sales are final. These are being sold $3 over our cost, so we are not going to field any phone calls that we have shipped used equipment as this is not the case. All units are brand new. The photo to the right is an example of one of the worse cases we have seen so usually expect a slight depression on one side. This is a photo (on the right) of a brand new unit with a crushed barrel. The dents do not effect the performance of the hot fog. While most or not dented, some can be.

From the manufacturer

Owners Manual

Burgess 982 Electric Thermal Professional Fogger

Our heavy duty thermal fogger is designed for a variety of commercial applications including: flood and fire restoration, odor control with deodorizers, and insect control.

With Barrel Attached: the fogger produces a dry fog. The secret to the success of the Burgess 16982150 Electric Thermal Fogger lies in its ability to produce microscopic particles that spread and penetrate any area being treated.

With Barrel Removed: the model 982 turns into a 2 ounce per minute, all-purpose electric applicator for applying water-based or oil-based material.

Effectively controls flying insects with oil-based insecticides or odors caused by fire, smoke, pets, mildew, etc. with oil-based deodorant. Can convert 1 ounce of oil-based insecticide into 2,000 cu. ft. of fog in just 2 minutes.

Key Features


Thermostatically Controlled Heating Chamber Heating element atomizes chemical into fine particles allowing it to float under and around surfaces for complete coverage.	Adjustable Flow Rate The flow rate can be adjusted based on the application for a wetter or dryer fog.	Durable Spun Aluminum Container Heavy duty reservoir holding up to 96 ounce of oil- or water-based solutions.



Assembly Instructions for Burgess 16982150 Electric Thermal Fogger	With fogger unplugged, inspect nozzle cap by pulling barrel away from fogger body as shown.	Inspect nozzle for accumulation of any foreign matter. Clean nozzle if needed before using and secure nozzle tightly.	Attach barrel by positioning the prongs directly in line with the slots provided for them in the housing. Push the barrel firmly into place being careful not to twist or bend the prongs.	Barrel should snap into place. Do not leave any gap between fogger body and barrel as shown.	After filling container with (oil based) chemical, be sure latches are fastened securely to lid as shown.



Troubleshooting Guide
	Symptom	Probable Cause	Correction Action
	Poor Fog Quality	1) Low voltage or 2) Incorrect extension cord	1) Change to another power source. 2) Extension cords must be 3-wire, 10, 12 or 14 gauge. Lighter cords may result in insufficient heating and insecticide leakage from end of barrel.
	Chemical Dripping	1) Nozzle loose, 2) Excessive chemical output, 3) Worn out barrel assembly, or 4) Other (see poor fog quality)	1) Tighten nozzle securely. 2) Adjust to drier output. 3) Replace with factory replacement assembly only.
	No Fog or Spray (Unit Vibrates)	1) Nozzle obstructed, 2) Pump plugged, or 3) No power at plug	1) Remove and clean nozzle with sharpened wooden toothpick (do not use metal object). 2) Insert wooden toothpick into hole at bottom of pump and pick out foreign material. 3) Check electrical connections, fuse, and extension cord.
	No Fog, Sprays	1) Worn-out barrel assembly or 2) Using water-based insecticide	Replace with factory replacement assembly only.

Operating Instructions

1. Allow the Burgess 16982150 Electric Thermal Fogger to pre-heat for two minutes or more.

2. Carry the fogger as you would a suitcase, holding it about 3 feet off the ground and away from your side.

3. Pull the trigger, conveniently located on the underside of the handle, to start the unit operating. Release trigger to stop.

4. Turn adjustment knob clockwise to obtain a dry fog. With a dry fog, you should see no moisture on a 8 inch x 12 inch minimum piece of paper or cardboard when you pass it through the fog about a foot from the barrel. Be careful not to place hand in front of the barrel.

5. For continuous use (more than 1 minute), be sure the unit is adjusted for a dry fog or liquid will drip from end of barrel.

Note: The fogger should only be operated indoors by certified, trained Fire and Smoke Restoration Technicians and certified, trained Odor Control Technicians and only in accordance with the IICRC (FSRT) Fire & Smoke Restoration Technicians and Odor Control Technicians (OCT) guidelines and standards.

Product description

The Burgess 982 Fogger is a commercial-grade fogger ideal for flood and fire recovery and eliminating pet or mildew odor.
Can also be used as a highly effective pest control fogger.
The same effective system used by professionals to kill mosquitoes.
Removing heating element converts it to a low volume sprayer/mister.
For thermal fogging only use products formulated specifically for thermal fogging - oil or water-based solutions containing propylene glycol oils.
These products are flammable and only certified professionals should use them.
Always follow chemical manufacturer instructions, warnings and safety guidelines.
Refer to SDS for proper use instructions and to verify compatibility with thermal fogging.
For low volume spraying (heating element detached): water-based and light oils may be used.
Heavy oils and other thick fluids will not work in this spraying mode.
Do not use wettable powders in the fogger as they will damage unit and clog nozzle components.
To get the most from your fogger use a dry fog - the dryer the fog, the smaller the particles.
Fog dryness is controlled by chemical flow rate through heating chamber, which is controlled by turning adjustment knob clockwise (counterclockwise for wetter fog).
Wet fog deposits film or residue, which may be desired on trashcans, pavement, or building foundations.
Never use wet fog on plants, shrubs or carpeting.
The oily residue could have damaging effects.
Keep fogger 10 feet away from area being treated and let fog drift in desired direction.
At this distance, any non-vaporized particles will settle to the ground.

Is is OK to use a thermo hot fogger with an EPA registered disinfectant?

Steambrite processes shipments daily by Fedex, UPS, and USPS (for small packages), as well as a using a variety of freight carriers for oversized/palletized shipments. While the Steambrite website DOES reflect what is available for purchase, it does NOT reflect available inventory at our local warehouse (San Antonio, TX). Special order, or custom build items may take up to 30 days to arrive, but orders shipped from within Steambrite's warehouse inventory are generally processed and shipped in 2-5 business days. Equipment small enough to be sent by ground should typically arrive within 3-5 business days after shipment. Oversized shipments could take in excess of 6-8 working days to arrive after shipment, and ground shipping times are not guaranteed.
Burgess Model 982, Electric Hot Thermal Professional Fogger, 115 volts AS42, FT982, 1614-1677, GTIN 841688003859 [AS42]

Click here for our full shipping policy. Specifications are subject to change without notice.
Steam Brite Inc shall have no obligation or liability to buyer whether arising in contract (including warranty) tart (including active, passive or imputed negligence) other otherwise for loss of use, revenue or profit, or any other incidental or consequential damages with respect to any non-conformance or defect in any items provided here under. Display images are for reference only, note that all purchases are fulfilled by the part number ordered. You our customer agrees to indemnify Steam Brite Inc and to hold it harmless from and against any and all claims, cost, liabilities, damages and expenses, including attorney's fees, resulting from personal injury or property damaged caused by the Products.
Warranty Disclaimer: Buyer's sole and exclusive remedy for defects in the products shall be as provided in the manufactures's warranty and any other rights provided by law against the manufacturer. Steam Brite, Inc makes no other than as specified in this agreement. All other warranties, express or implied, including but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are hereby disclaimed.

This product was added to our store on Monday 17 November, 2008.