|
|
#1
May 16th, 2009
|
|||
|
|||
changing vacuum hose size
i have a portable sadia extractor. it has a barbed 1.5" vac hose port. can i remove this and install a 2" port and thus increase the length of hose i can run? where would i get a compatible 2" barbed connector for this Sandia? it also seems very difficult to reach the inner part of the port. any suggested tools or if i put a wrench on the outer piece, will it just come off? interested because i would like to get a Spinmaster tool.
Last edited by The Floor Guy; May 16th, 2009 at 09:30 PM. 
|
|
#2
2 Weeks Ago
|
|||
|
|||
|
Up grade your portable extractor to 2" ID hose
You can install a 2" port on the lid and then cap off the port that is on the machine. This has been done in the past with good results. I have some photos I will load to our website.
http://www.steam-brite.com/store/sha...er-p-8655.html Last edited by Donald; 2 Weeks Ago at 03:47 PM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
